Halo Covenant Wrist Shield Generator

Discussion in 'Replica Props' started by Wes R, May 16, 2012.

  1. Wes R

    Wes R Legendary Member

    Trophy Points:
    6,750
    From the notebook that came with Reach. This pic is what i'm basing my design on.
    [​IMG]
    You can see how different they look in some of the games and i'm not sure why.
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    [​IMG]
    Here's what I have so far:
    [​IMG]
    I got 2 pieces of the same pipe at lowe's for like 7.00 and cut the thinner part off one (their selection is crap) and with just a tiny bit of dremeling they slid together.
    [​IMG]
    [​IMG]
    It's too small for my hand and fat arm but it should fit my friend. I have to keep dremeling out the threads and sound the outside. Then just put in a piece of something as the flat crossbar the generator part is hooked to.
    Here is the generator dome and the other part it hooks to. I made them from pure fiberglass resin in some molds i had laying around that looked right. I'd love to do the large shield like in the game but i don't have anything to make it out of. It would have to be vac formed.
    [​IMG]
    So far this isn't that bad a build and with luck it will keep going smoothly.
     
  2. lunar lord

    lunar lord New Member

    Trophy Points:
    17
    looking great so far cant wait to see more !
     
  3. Wes R

    Wes R Legendary Member

    Trophy Points:
    6,750
    I'm going to look for one of those cheap recordable cards and put some sfx from the game on it. they're really not right for this prop but they are shield sounds and i figured it would be neat.
     
  4. leetninja

    leetninja New Member

    Trophy Points:
    3
    a noble en-devour
     

Share This Page