RPF PREMIUM MEMBER
If you're interested in getting a kit, please feel free to post a reply with number of kits and which type (i.e. One Deluxe Kit).
Please be aware that none of the kits include the stylus (Rectangular), flash hider nor push rods. These parts can be purchased from Field Marshall.
Side Rods (2x per kit) (pending): $30
Side Rod Points (2x kit) (pending): $38
Sight Rod w mount (in stock): $18
Sight Rod mount (in stock): $10
Rear sight (pending): $17
Cast Black Resin Pontoon (in stock): $6 each
Barrel Extension (in stock): $43
Trigger Guard (Resin - in stock): $15
COAX Reducers (2x per blaster): $3 each ($6) (In stock)
Rear black cap: $1 (Free with Kit)
Trigger Guard (Aluminum): $80 (by Request)
Standard Kit (Includes all parts above - one Pontoon included - accept the Trigger Guard, COAX reducers and Flash Hider): $152
Full Kit (Includes all the parts above - one Pontoon included - accept COAX reducers and Flash Hider): $167
Deluxe Kit (Includes all the parts above - one Pontoon included - accept Flash Hider): $173
What you will need to complete your blaster: Tone arm rectangles (2x), Reade Model Kit rods (2x) and Flash Hider/Grill (1x)
These parts can be purchased from FieldMarshall via vmusicstore on ebay. See below for more information on additional parts.
Update (as of 7/22/21): The waiting list is closed and I have started machining parts. My goal is to finish off what is left of my parts, turning them into kits and retiring the runs.
I'm estimating that the general run will be completed by 7/31.
The machined trigger guards will be completed by 8/6
Once completed, I will send each of you a pm with a total for your payment, so save your pennies!
Waiting list for kits:
1. JetSetWilly (Deluxe Kit)
2. dse2187 (Deluxe Kit)
3. JLinNY (Deluxe Kit)
4. Gaffer (Standard Kit with aluminum trigger guard)
5. CE (Deluxe Kit)
6. Rattlesnake toys (Deluxe Kit)
7. KJKelley (Deluxe Kit)
8. Darthwilder (Aluminum trigger guard - real rugger, 2 side rods with points)
Additional parts info:
Original Reade Model flash hiders, small "push rods" and machined Rectangular stylus parts for the side rods are available on ebay:
DL44 Hansolo AMH 3 cylinder heat sink greeblies KIT. Original found parts made by READE models for the anh front heat sink and sight greeblies.
Replica Rugers (by KJWorks) like the one pictured below are also available on ebay from unlimitedwares, although listed as "KJW Airsoft MK1 Luger".
KJW MK1 Green Gas Airsoft Pistol Gun. Airsoft BBs & Accessories. Airsoft Pistols. Airsoft Rifles. 450 Feet Per Second Projectile Velocity. Airsoft Shotguns. Airsoft Snipers. Rifle & Pistol Accessories.
Barrel Extension Install:
Use a ruler to mark the brass rod a little over 2" from the end (about 2 1/16"). Use a hacksaw to cut off the 2".
Use a belt sander to round off the edges of the brass tube. A file and/or sandpaper can also be used. Test fit the barrel extension. Be sure to turn the part so that the notch is near the top of the barrel:
Once fitted in place, use a small tool to tighten the set screw near the bottom edge of the barrel extension.