Gauntlet Window Demensions?

Robiwon

Master Member
Gone but not forgotten.
I am having an electronics company build an animated gauntlet timer display for my costume. Does anyone have demensions of the windows size and spacing? I would like this to be as accurate as possible. Oh, and this will be a kit that will be available in the near future. I'm going to search, but I need the demensions by Tuesday as that is when the next order for printed boards goes out. I will pass on more info on this project when I can.
Thanks.
 
depends on if your talking P1 P2 AVP AVP-R or Predators. All are different, at least I think
 
Thanks guys. I am using the deminsions provided in the link above. The boards were sent out yesterday for printing. Should be back soon. The timer will turn on with a push button. Pressing a second button will start the countdown timer until the last one blinks off. More info to come as I get it from the producer.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top