Gamorrean Guard axe question

jango5204

jango5204

Well-Known Member
I'm going to start making this axe for my Gaomrrean Guard suit that's currently being made. I was going to use my styrene sheets to make the blade. I want to know if anyone had a good method to copy the texture in the side of the blade. To me it looks similar to the texture of the 300 helmets. Thought about heating a rasp and pushing it into the plastic, but that would look too uniform. I'm afraid I would warp the blade if I heated the plastic.

100006_press15-001.jpg

Gamorrean_trio_btm.jpg
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top