Limited Run Full Size M-O from WALL-E

gooses2

Active Member
This is a 1:1 scale model of M-O (Microbe Obliterator) from the film WALL-E.

Offering kits and finished models. Body will be fibreglass while head, neck, arms brush and ball will be resin. Backpack and brush protector will be vac-form pieces.

The model is not completely finished at this point, but it will be before moulding and casting. The eyes you see here are just pieces of card, the final model will have LED eyes. Detail is also missing from his hand which needs to be added. The paint job you see here is not final as he is missing his black strip on the body.

I'm looking for £300 for a raw cast with vinyls for painting.
£500 for a fully painted model.
Wired and Soldiered LED kit will be an extra £50.

Deposit will be £100 to cover moulding costs.

Starting with a run of 5, but might expand it later if there is enough interest.

1.
2.
3.
4.
5.

attachment.php


attachment.php


attachment.php


attachment.php


attachment.php
 

Attachments

  • fullwhite.jpg
    fullwhite.jpg
    177.1 KB · Views: 1,671
  • back.jpg
    back.jpg
    126.3 KB · Views: 1,039
  • full.jpg
    full.jpg
    149.1 KB · Views: 1,003
  • head.jpg
    head.jpg
    122.1 KB · Views: 1,001
  • brush.jpg
    brush.jpg
    108.1 KB · Views: 818
Very interesting !, what size is he, interesting now BB8 droid whether this could be made movable..
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top