For everyone looking for a fallout 4 pipboy

jellis359

Jr Member
So someone already made complete files for the pipboy for use with a 3d printer. You can find them here.
http://ytec3d.com/pip-boy-3000-mark-iv/

If you don't have a printer use 3dhubs.com to find local printers willing to do it for you.
prices are usually much better than shapeways

Sent from my C811 4G using Tapatalk
 
Thanks for posting this. I have taken a copy and bookmarked the instructions, it looks like a really informative set of instructions. Respect to Dragonator for his good work.

I do have a preorder of Fallout4 Collectors edition, but may attempt this version sometime too.
 
Keep in mind guys, he has three different size set ups for the new one. The older pipboy was just one size, and he said he had a lot of complaints about people scaling them then throwing the hardware requirements out of whack. He set the new one up in different sizes to help in this regard.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top