Foam blades

Thread starter IronDog
Start date Aug 23, 2008

IronDog

New Member

Aug 23, 2008

Ok situation-

I've just finished up my blade guantlet and done a rouch mock-up of my blades in 3mm foamies.

Question- is there any way to give the foamie blades more rigidity? If I coat them with PVA would it stiffen them up any?

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.