Alexander527
New Member
Hey everyone just started a Bale Cowl as my first project ever and am very excited! I used "Ruze789" pepakura file as a starting point. I printed on regular paper just as a test to see if adjustments need to be made for sizing, I plan on printing on cardstock once I finish adjustments to the paper model.
Here are some pictures of it so far:
I'm still not sure whether I should make a latex cast of it or go a different route. I also saw a method by user "omel" where they used duct tape, plumbers putty and spray paint to build it up; this method appeals the me the most.
Link: http://www.therpf.com/f77/budget-batman-tdk-ver-3-wip-pic-heavy-191262/
Any suggestions on how I should go about it would be greatly appreciated!
Here are some pictures of it so far:
I'm still not sure whether I should make a latex cast of it or go a different route. I also saw a method by user "omel" where they used duct tape, plumbers putty and spray paint to build it up; this method appeals the me the most.
Link: http://www.therpf.com/f77/budget-batman-tdk-ver-3-wip-pic-heavy-191262/
Any suggestions on how I should go about it would be greatly appreciated!
Last edited:
