First Airbrush? Iwata

Turdbol

New Member
I am looking to purchase my first airbrush. I have two velociraptors that need painting, so I finally have an excuse to buy one. I think I have narrowed it down to these three and would appreciate any input and/or advice or other suggestions! Thanks

IWATA REVOLUTION
http://www.amazon.com/Iwata-Medea-R...?ie=UTF8&qid=1433311683&sr=8-6&keywords=Iwata

IWATA ECLIPSE CS
http://www.amazon.com/Iwata-Medea-E...?ie=UTF8&qid=1433311683&sr=8-2&keywords=Iwata

IWATA ECLIPSE BCS
http://www.amazon.com/Iwata-Medea-E...ie=UTF8&qid=1433312791&sr=8-17&keywords=Iwata

I am slightly leaning towards one of the Eclipse models because it says it can do a hairline, whereas the Revolution can do I think 1/32". I also really don't know the difference between the two Eclipse models? However, I would love to hear your advice!
 
Last edited:
The Eclipse CS is gravity feed, the BCS is bottle feed. Gravity feed is best for fine detail work because it can spray with much lower air pressure. Of those three I'd recommend the Eclipse CS for the gravity feed and fine line ability.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top