Finished 3 DH-17 types ANH, ESB and ROTJ

3DpropsNL

New Member
I finished three new DH-17 models for my shop, the ANH, ESB and ROTJ version. We are working on the R1 version as well.

ANH - Still working on a better SP scope cap / cone
IMG_3615.jpgIMG_3614.jpgIMG_3611.jpgIMG_3617.jpgANH A.jpgANH B.jpg

ESB
IMG_3625.jpgIMG_3624.jpgIMG_3621.jpgIMG_3628.jpgESB A.jpgESB B.jpg

ROTJ
E.jpgC.jpgA.jpgG.jpg21895271_1277127582409280_1355736467_o.jpg21908574_1277127465742625_669449505_o.jpg
 
Very nice to see the E-11s less glamorous sister getting some love! I love the attention to the difference between the models!
 
Last edited by a moderator:
I used a cough syrup spray clear cap. Chloraseptic I think was the brand. Fit nicely on my resin single point scope.

- - - Updated - - -

Nice work by the way.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top