Fine Molds' TIE Interceptor

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


Boba Flint

Sr Member
RPF PREMIUM MEMBER
Mine arrived today.
Here are scans of the main parts for your enjoyment.
47b3cc10b3127cce8571df45cae90000001610

47b3cc10b3127cce8571df31ca9d0000001610
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Clerval

Sr Member
RPF PREMIUM MEMBER
A ton of folks have been finally getting them. Nice when you only have to 'do up' a new set of wings, hm? A really nice job.

This spring will be the big one for most folks and Fine Molds as far as SW is concerned... can't wait.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Clerval

Sr Member
RPF PREMIUM MEMBER
Studio Scale? Not even close... these are 1/72, only about 5-6 inches long. The Slave 1 will be much bigger, closer to the MPC kit. The kits at least are all in scale with each other.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top