Fine Molds Millenium Falcon

Haven't seen one, but sorely needed. I don't think I've ever seen a part like that molded in resin--I mean, it wouldn't have a pour stub to speak of if it's done right. At least I can't envision it.
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.