Interest Falcon Respirator, Hoth Binocular, Hoth Scanner, & HIC Machined Aluminum Parts

[TatooineMachine]

Please edit your interest post in bold and let me know how many of each part you’re interested in, thank you!

 

[OdiWan72]

Already have the needed number of clamps and inserts (TWO OF EACH PLEASE) in my original post

if you do the small coned pieces, I‘d need 8 to 10 of these

 

[Cantina_Dude]

Please count me in for the following:

Split Clamp x 3
Two Tube 4 Hole Shaft x 2
Small Coned Piece x 2

If you are doing the Michell knurled knobs out of chrome plated steel and with the correct 45° helix knurl instead of the 30° helix knurl more commonly seen on modern replicas people make of Michell parts I would be down for 2 of those.

Thanks!

 

[Rafite]

Please add me for the part on the Electrobinoculars, and a complete set for my personnal Hoth scanner, not sure how many it takes...

 

[kurtyboy]

Interested in all the Hoth scanner parts and electrobinocular parts.
Split Clamp x 3
Two Tube 4 Hole Shaft x 2
Michell knob x 2

 

[Cameron]

Yo Chadster. Put me down for 2 Mitchel Knobs and all parts for Scanner

 

[mgoob]

1x Split clamp (electrobinoculars)
1x Two Tube 4 Hole Shaft on top of the Split Clamp (electrobinoculars)
1x Michell Knurled Knob (rebreather)

 

[mgoob]

Already have the needed number of clamps and inserts (TWO OF EACH PLEASE) in my original post

if you do the small coned pieces, I‘d need 8 to 10 of these

Are the small coned pieces used on anything else?

 

[OdiWan72]

Are the small coned pieces used on anything else?

From what I can tell, these are used on a variety of props

 

[kurtyboy]

From what I can tell, these are used on a variety of props

Vader Reveal.

 

[thd9791]

Interested in 2 Michell Knobs

 

[Mickxc]

Interested in 2 small Michell cones for Vader reveal if your making them

 

[TatooineMachine]

List updated, thanks!

 

[cdyoung]

Updated. Thanks, TatooineMachine.

Split clamp x3
Shaft x2
Michell knob x2

 

[TatooineMachine]

All pieces have been dropped at the machinist for review!

 

[Jamesfett]

Vader Reveal.

Can you explain where?

Are these the ones shown with the Genuine Michell Knurled Knob?

Thanks

 

[kurtyboy]

The tips of the "nutrient tubes".

Can you explain where?

Are these the ones shown with the Genuine Michell Knurled Knob?

Thanks

 

[Jamesfett]

Could I get:

1x Michell Knurled Knob

2x Small Cone Vader Reveal Pieces

 

[TatooineMachine]

I would like to get some input on the two tube four hole shaft -

1. Markus believes the two tubes are 7mm OD - any objections?
2. Any opinions on the four hole sizes?

thanks!

 

[OdiWan72]

I would like to get some input on the two tube four hole shaft -

1. Markus believes the two tubes are 7mm OD - any objections?
2. Any opinions on the four hole sizes?

thanks!

Cantina_Dude modeled the whole scanner... could you please share the dimensions you came up with for the part in question?

Thanks buddy.