Ewok Build

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Gumbyack454

Member
Hi, I am in the middle of building a Ewok prop and was wondering if anyone had any Ideas as to what I could use for the Teeth. Thanks
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Purple Dagger

Active Member
I would say low budget some oven bake clay, superscult perhaps. Other wise if you want to cast them out dental plaster would give a good look or resin but you would have to paint the resin, where as the plaster you could weather then be sealed easier.

Kind of depends on the lips, do they move? open or closed static mouth?
 

Gumbyack454

Member
The mouth doesn't move, it's just going to be sitting there. But the clay idea is a good idea I will use that. Thank you!
 

frosty

Sr Member
i've used polymorph plastic, otherwise known as magic plastic, comes as small pellets which you heat in water and then shape by hand into teeth fangs whatever, once it cools its sets rock hard into a translucent white plastic which with a bit of shading looks like teeth
heres a link to some on ebay, so you know what to look for
250g Polymorph Thermoplastic Friendly Plastic DIY | eBay
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

ob1al

Sr Member
Polymorph looks brilliant, a million uses around the home and in prop making with that stuff - definitely getting some to play with!
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Gumbyack454

Member
Thanks, I'm going to be working on the body very soon. I'll be doing a PVC mannaquin I'm just trying to figure out what I want to stuff the body with. If anyone has any ideas I would appreciate the help.
 

Andrewshaddox

Active Member
Hey, Great Build!!!! Im at the same point in my build...I used scrap ABS for my teeth and oven bake clay for the mouth and nose.

I saw a guy who, for the body, did the PVC mannequin, wrapped that in either foam or bubble wrap to get the body size, and then duct tape around that to make it more solid. I think they just attached the fur from there. Thats what i was thinking of doing for mine...

 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top