epoxy usage

Agitomega

New Member
http://www.therpf.com/f24/smoothcast-vs-resin-fiberglass-193685/
So apparently from this thread the usage of polyeurathane is 2x of using fiberglass resin is that true for epoxy as well?

Also if you noticed the pricing between smoothcast and epoxamite. the pricing of smoothcast is 2x 1 pint which is a quart compared to 2x 1 gallon at 3x the cost but 8x the resin. while epoxamite is a quart to a gallon at 3x the cost but 4x the gallons which means it polyeurathane gets a better deal why is that? is it because it can use less and therefore a bigger bang for my buck either way?
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top