Entex StuG part help

ckwanwoo

Sr Member
Hi,

I'm currently rebuilding the Turbo Laser and need some help from you guys.
My old version was oversized and all dimensions are remeasured/rescratchbuild...

Firstly, I used Bandai StuG for my old version, however, it was originally from Entex StuG as the attached.

If someone has any casting or original part, please let me know~

Thanks,
Eric.
 

Attachments

  • image.jpg
    image.jpg
    101.3 KB · Views: 169
  • image.jpg
    image.jpg
    643.2 KB · Views: 163
Eric,

I haven't emailed since I haven't had any emails from you. The 1/15th entex stug should be the same as the Bandai.

Regards,

Jamie

Hi Jamie,

Long time no chat friend.
Regarding the Devastator, I have sent an email because I found some unIDed part...
However, no response...Pls contact to me :)

Thanks,
Eric.
 
Hi Jamie,

I resend the email from ckwanwoo6129@daum.net to jf7277@h...com.

With regard to StuG, I heard that ILM used Entex kit for ANH models.
Since my Bandai StuG is slightly different with the Turbo Laser part...especially the texture, so, I thought it was from Entex StuG.
Please can you confirm? or any kit used for the Turbo Laser?

Thanks,
Eric.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top