Endo skull build wip

falloutboy

Well-Known Member
RPF PREMIUM MEMBER
This will be a mixed media project. Resin printed, full size skull, and found parts where I can.
Figured some would like to see a build thread though :)
20220629_230127.jpg
 
Last edited:

falloutboy

Well-Known Member
RPF PREMIUM MEMBER
First test fit after priming. Need to sand down the jaw pins a little, and some careful filing of the cpu core holding socket inside
 

Attachments

  • 20220701_184532.jpg
    20220701_184532.jpg
    3.5 MB · Views: 37
  • 20220701_184546.jpg
    20220701_184546.jpg
    3.1 MB · Views: 33
  • 20220701_184522.jpg
    20220701_184522.jpg
    3.2 MB · Views: 34

falloutboy

Well-Known Member
RPF PREMIUM MEMBER
Designed my custom jaw pistons (engineering resin, aluminum tubing, amd m3 screws) springs should be in tomorrow. Not sure I'll use them, but nice to know that I could make them semi fun-ctional pistons if desired.
20220706_200417.jpg
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top