E-11 build...need aome assistance :)

Bad Wolf

Sr Member
hi all

I want to attempt an E-11 build...have a set of Doopydoo's parts and the pvc tube.
I want to get the cuts in the pvc correct and was wondering if anyone could point me in the direction of a template for all the holes, slots, etc I need to make?

any and all help would be greatly appreciated.

thanks much :)
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.