Dumb question: Dia. of the Graflex across the grips?

Rodann

Sr Member
Yeah I know....I should know this!:lol

I'm making a stand for my Luke ANH Graflex, which I'm still waiting on parts for, and I was wondering if anybody could give me a quick measurement across the rubber (Blastech) grips. The front diameter wouldn't hurt either, but I didn't want to guess on the back end.

Thank you in advance.:)
 
I should add that I don't currently have the complete saber, and I have a small window of opportunity to finish the stand here at work;)
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top