Dremel Miter saw?

[asok]

Does anybody know of a way to make a Dremel into a miter saw? Or some sort of attachment? I am cutting some very small parts out of sintra and I need to have them with nice right angles.

Thanks,
Asok

 

[Harlock]

I would recommend getting an X-acto razor saw and miter box. Nice for small stuff like that.

Razor Saw

Mitre Box Set

 

[BarryZ28]

Are you talking about something like this?
http://www.harborfreight.com/cpi/ctaf/Disp...temnumber=42307

 

[Sluis Van Shipyards]

I have one like that Harbor Freight saw, except I paid a lot more from Micro Mark... It works really well for small parts. Micro Mark has a heavier duty version too.

 

[Harlock]

I'm not a big fan of Harbor Freight's stuff. I've returned more than I've kept from them.

 

[cobywan]

I have that HF saw. I made a new table that replaces the jaw vice. It's sort of a cross between a saw and "the Chopper" that's used with Evergreen styrene products. It's been working really nice. The only problem I had with the saw was a bad switch. I popped it out and back in and it started working again. For $20 it's a great tool. I need to post a photo of my modifications.

 

[shrugger]

Yes I think you do need to post pix of that. LOL

I have the HF saw as well. I've used it to cut nearly
500 bits of brass tube for the 'ol 44" Eagle. No problem.
I have however, gone through 12 saw blades. :eek
Which means I've spent 4x more for the blades than I
did for the saw. :lol

 

[cobywan]

<div class='quotetop'>QUOTE(shrugger @ Dec 26 2006, 02:58 PM) [snapback]1384757[/snapback]</div>

Yes I think you do need to post pix of that. LOL

I have the HF saw as well. I've used it to cut nearly
500 bits of brass tube for the 'ol 44" Eagle. No problem.
I have however, gone through 12 saw blades. :eek
Which means I've spent 4x more for the blades than I
did for the saw. :lol
[/b]

Here it is.