Door to Heaven

I'm very impressed. At first I just thought you were making a static resin model, but lights and all that... very cool.

Russ
 
I saw it at FACTS Convention this weekend.

I spent some minutes taking close-ups of it with my videocamera. If I upload it on Youtube I'll link it ;)
 
Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this.

Wow.
Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this.

Tom

P.S. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this. Must have this.
 
I had some inquiries about making an Atlantis gate,
and I have been thinking about how to build the Atlantis Gate, and I think a lot of
problems could be solved by casting in a transparent resin, like epoxy.

you would only need to have some leds at the back of the glyph patterns
to have a good looking glyph.

I will make a test and take some pics on how this would look.

anybody know how the Atlantis gate light sequence looks like ??

Xeno
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top