Destiny Warlock helmets and more


made007

Sr Member
Its been awhile since i posted progress
QE props commisioned this file, you can find it on his thread
i scaled it down, this is the third try, as it was too big at first
4D28BAD9-2D45-4466-8E7E-6B133C1F08FD_zpsaloyuoym.jpg

7D71FCEE-2B1B-4E3C-87C5-C30BD6B0B0A4_zpsyai95k7b.jpg

38DAC0C9-598E-4F25-B787-9460706DA2FF_zpsr17zj2ki.jpg

D646D488-89E5-41F7-88C2-47145EE1414F_zpsra9pdu6z.jpg
 

LancLancDoubleD

New Member
Looking good so far. Are you going the simple heat molded acrylic route for the visor like QE did? What material did you use to make the ear cup "wing" details?
 

made007

Sr Member
Looking good so far. Are you going the simple heat molded acrylic route for the visor like QE did? What material did you use to make the ear cup "wing" details?

I used styrene plastic sheet for that
and for other details i used the sticky back foamy technique i learned from impact props
i think ill use my vacuum former for that visor, i dont know wich route to go yet
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top