Destiny Thorn


TheDoomedOne

New Member
Recently I decided that I would make Thorn for my Dad's birthday. I will be using MDF, and will probably be making a cast of it.

I made a set of templates based on promotional art for the weapon. Based on the references I have found this is full scale (21in. length). I will be printing mine at 85% of the image size.

View attachment 8UGcb8z.png

The only thing I think will give me trouble is the cylinder gears, so if anyone has any advice I would be very appreciative.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top