Destiny - Pocket Infinity ( in progress)


Von Props

New Member
i'm working on the pocket infinity from Destiny.
this is my first time using Solidworks or any 3d drawing software for that matter.
(i'm not there yet but it will be my first time casting too)

here's where i'm at.
progress%201.2.png

I plan on 3d printing the parts, then make a mold out of it and cast it in resin.

hopefully when i'm done it will look something like this !
Destiny-PocketInfinity-ExoticFusionRifle.jpg

Let me know what you think. ( any tips or tricks are welcomed )
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top