Destiny 3D printed ghost prop


New Member
This is a 3D printed ghost I recently finished. I hand painted it with acrylic paint. The weather I did with a silver sharpie wiped on a paper towel and scratched along the edges. I say it turned out well.
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.