Dawn Of Justice armored Batman

KadzaNeon

Active Member
GET FILES HERE WHOOT WHOOT!

For Paper

HELMET---http://www.4shared.com/file/sX2vAAnsba/HelmetLOCKED.html
Helmet.jpg

CHEST-----http://www.4shared.com/file/0wku0lGOba/Chest-LOCKED.html
Chest.jpg

ABS---http://www.4shared.com/file/bifdEsktce/AbsLOCKED.html
Abs.jpg

SHOULDERS---http://www.4shared.com/file/NPGH47HPce/ShouldersLOCKED.html
Shoulders.jpg

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

FOR FOAM

A big thanks to Southpaw for doing the unfolding of the foam files, thanks bud!

Here is set 1 which includes Helmet, chest/back, shoulders, abs, bicep and forearm parts.
Get them Here these files are the unlocked versions
http://www.4shared.com/zip/aHUueMEmba/Unlocked-Foam_Bat__Armor_set_1.html

Set 1-01.jpg




20150517_145350.jpg 20150517_145319.jpg
Hey guys,
I've been working on an Iron Man mrk 45 3D printed armor. It just takes so damn long to create armor which is 3D printed so i wanted to make an in between costume and though armored batman would be fun to make in foam. So here we go ^_~

Above is the start of the leg armor made in foam. Below was another armored Batman costume from DCU online I made a few years a go. It was made using pepakura and epoxy clay, Not fun to wear but looked cool in photos.

cosplay-8259.jpg cosplay-8279.jpg cosplay-8296.jpg cosplay-8303.jpg
 
Last edited:

KadzaNeon

Active Member
Very nice and clean. What are you using to cut your detail lines?

Im using this little guy here. you can find them at home depot. it's very useful because you can extend the blade out very far for angled cuts. also you can snap the blades off so you always have a nice sharp blade.
DWHT10037_P1_500X500.jpg

- - - Updated - - -

That's some really nice foam work.

Thanks bud!

- - - Updated - - -

Anyone feel like doing the pep work on my 3D model? I just have to much going on at the moment.

Front.jpg p1.jpg p2.jpg p3.jpg p4.jpg Side.jpg
 

Gideono

New Member
Ahhh, my bad. I didn't know what the armour was called. Good luck with it then and if you find a foam file post it pleasseeee :)
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top