Daft Punk Guy Manuel Helmet

Discussion in 'Replica Props' started by markxdye, Feb 23, 2012.

  1. markxdye

    markxdye New Member

    Trophy Points:
    2
    Hello I'm new to the rpf and was referred by someone on a diy site.

    I already have the helmet made, I'm just clueless on the electronics. Volpin made his own circuits and got them printed, but is there any kits or anything I could put together to achieve the same thing? Maybe some chasers and such that would be all synced together.

    If the only way to do it is to design the boards and get them printed myself, im fine with that, but if that's the case, can anyone point me in the right direction of what I will need to learn to do this. So far I only have the ability to solder, and no other electronic knowledge.

    Someone told me I would basically need to learn everything, so I basically am asking for the resources or tips to learn what I need to learn. School doesn't have any classes available.

    I've only previous soldered el wire and jewelry in highschool, but am pretty sure I have it down.
     

Share This Page