Custom P1 biomask

Thread starter Xmachine
Start date Jul 9, 2010

Xmachine

New Member

Jul 9, 2010

Hi all!! Here is my second biomask that i sculpted and coated with fiberclass. My idea was to make P1 that will fit to my head without halfmask so now i only need to add lasers and foam the bio+make latex backside for that mask where the dreads are going to be attached and maybe a latex chin piece to make it look more real if you guys have any tips how to make it look more realistic without a half mask i would be happy to hear those

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.