Custom Keyboard Cap

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


MulletMan28

New Member
I have printed a custom keyboard cap as an experiment with a 3D printer. I am trying to cut out the mounting point that the cap goes into on the keyboard, and I am looking for the best way to do so.

The black key is from the keyboard itself. The grey is my 3D-printed one. I need to copy the post from the original key to the key I made and I can't figure out a way to transfer a line layout onto my key or draw it on freehand. It may be something simple, but I can't think of how to do this.
 

Attachments

  • IMG-1705.JPG
    IMG-1705.JPG
    2.2 MB · Views: 34
  • IMG-1706.JPG
    IMG-1706.JPG
    2.2 MB · Views: 31

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top