Reply to thread

Message: <blockquote data-quote="division 6" data-source="post: 2040140" data-attributes="member: 1710">This should actually be posted in the props section.Anyway, I would start with threaded rod for attachment to the cane.over that probably assorted bolt and washers then use steel epoxy 2 part plumbers putty.It comes in a stick that you just cut off a piece then kneed together (the catalyst is in the middle)it kicks and cures really fast and is super strong so you have to work fast.Once all the sculpting and clean up are done primer then paint.if at all possible use automotive paints since once cured they are able to stans up to handling, if not then a clear coat may be required but will dull the finish.Another option is using (I think it's called) "Rub On" wax paste.Comes in a tube and can be found at places like Micheal's.I've seen some really nice finishes on helmets using it but it does require a lot of buffing.</blockquote>

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.