Clutch Pin/Insignia Construction?

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


rickhoward

Well-Known Member
RPF PREMIUM MEMBER
I'd like to remove the pin pieces from the backs of a few clutch pins/insignias, but don't know how they are typically attached. Does anyone know how these are assembled? Glue, weld, ??? Thanks!

2019-05-12_10-56-56.jpg
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

rickhoward

Well-Known Member
RPF PREMIUM MEMBER
I've not ruled that out. Ideally I want the back to be perfectly flat, and don't want warp/damage the face of the thing.
 

Riceball

Master Member
I'd just Dremel it off and then sand the back. Alternately, you could, as was suggested above, just snap it off, if I'm not mistaken they're just glued or lightly welded on, I don't think that they're an integral part of the pin.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top