Clonetrooper Combat Infantryman Badge - Clone CIB

TI6815

Well-Known Member
Hi RPF

I like to show you a new Project
I create a Clonetrooper Combat Infantryman Badge ...similar to the CIB awarded at the US Army. The Prototyp is 3D printed in two different sizes. Now I will cast it with resin and like to ask you for feedback.

Maybe I will make a smal run of this Plates in the future.

Have Fun

Kai

IMGP4076.jpg

IMGP4073.jpg

IMGP4078.jpg
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top