Reply to thread

Message: <blockquote data-quote="Howlrunner" data-source="post: 3729515" data-attributes="member: 4257">Been working on her all day on and off, so ears are now built.  Just sanding and gap filler on them to go...The next two pieces I'm not sure on - anyone got any good ideas?  I need two truncated cones for where the ears attach to the head, and another slightly larger one for where the head attaches to the neck.  I'm been looking at plastic shot glasses, hair and shampoos lids, all sorts in the supermarket today, but nothing with the right gradient on the sides.  Need something with a bottom diameter of 3cm....Also, open to ideas for the neck.  Something flexible would be good, but static is also fine.  Can't find anything with the correct gradient again, as it's narrower at the top than at the bottom.  I did see a glass bottle that looked about right, but do not want to have to cut glass - must be plastic, wood or something dremel-able!</blockquote>

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.