Civil War Crossbones vest, need advice

Zombie Hadouken

Active Member
trying to make the vest from the Civil War promo shots.
frank-grillo-is-unmasked-as-crossbones-on-civil-war-set.jpg
I have acquired a Bear Tactical riot gear, mocked up where to cut it (red for cut lines, yellow for adding shoulder plates)
crossbones vest.jpg
this riot gear is a very thick heavy strong plastic, so any recommendations on how to cut it?
I dont want to use the wrong tool or method and ruin it as it is too expensive to ruin and replace.
any help or suggestions are very welcome.
 
youve got the right idea. im justv gonna use eva foam or sculpt my build. i cant recall what i readc on which plastic they used, but i deemed easy enough to break out a dremel or the angle grinder with cutting wheel. just try to be accurate as possible with the shape.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top