Civil War Crossbones vest, need advice


Zombie Hadouken

Active Member
trying to make the vest from the Civil War promo shots.
frank-grillo-is-unmasked-as-crossbones-on-civil-war-set.jpg
I have acquired a Bear Tactical riot gear, mocked up where to cut it (red for cut lines, yellow for adding shoulder plates)
crossbones vest.jpg
this riot gear is a very thick heavy strong plastic, so any recommendations on how to cut it?
I dont want to use the wrong tool or method and ruin it as it is too expensive to ruin and replace.
any help or suggestions are very welcome.
 

DizzyStrmtroopr

Well-Known Member
youve got the right idea. im justv gonna use eva foam or sculpt my build. i cant recall what i readc on which plastic they used, but i deemed easy enough to break out a dremel or the angle grinder with cutting wheel. just try to be accurate as possible with the shape.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top