Chestburster Sculpture help

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


randy7027

New Member
I am sculpting a chestburster. now I need a little bit of help..how should I do the mouth? Open with teeth? if so how do and should I make the teeth? also how do i make the textured skin lines and the ring lines on the tail?? help? I do have reference but dont rlly know how to do it. plz help.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

delonghi

New Member
you could try the corrigated plastic hose for the ribbed tail, mouth open looks good try thin plastic cut v shapes out to get sharp points and colour them silver

18ynpe.jpg


21mg4gg.jpg


this is a alien queen just to be differant

b7zakn.jpg
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top