casting alien skull 1/6

georgieboy26

New Member
hi guys I have the alien skull with pred2 battle damaged version, also the non battle damaged pred, I want to make a copy of the skull from my original to put with the non battle damaged figure..........what is the best way to go about making a mold from the original skull? silicone rubber maybe...although would be tricky as the skull shape is complex......any ideas on how to would be great
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top