Carving Foam- Pattern application help

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


Jut780

New Member
Hey guys, new to the forum and website...

I have been shaped indoor rock climbing holds for various commercial indoor climbing hold companies as a side hobby and had a question related to some detailing that some other companies have been using.

Has anyone seen a dremel bit or other tool that could create symmetrical patterns like that shown in the picture below? Thanks in advance!
 

Attachments

  • bubble-wrap-001.jpg
    bubble-wrap-001.jpg
    202 KB · Views: 144

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top