Cardboard Thor's Hammer

Discussion in 'Marvel Costumes and Props' started by OBI WAN KEN0B1, Sep 2, 2015.

Tags:
  1. OBI WAN KEN0B1

    OBI WAN KEN0B1 Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    1,036
    Well after a very long road i can say i am finished with my Hammer. Its made from a basic design that i drew up and as close of measurements that i could find. I lost most of my Progress pics when my memory card died on my phone. Its basically just cardboard with a giant bolt thought the middle with two 2x4"s in the center for weight. Then Fiber glass sheets and then resin over the fiberglass and resin on the outside. Then Filled with expanding foam. Then the basic bondo and sanding it kinda smooth ;). That's it the Handle is just a 1 1/2 inch dowel rod with a hole drilled in it and a nut glued in for the bolt. Finally a little paint and weathering. The side runes and the top i had 3D Printed at shapeways and they are my own design. Let me know what you think with the few pics i have.

    20140919_201037.jpg 20140919_201032.jpg 20140919_201029.jpg 20150901_190456.jpg 20150901_190512.jpg 20150901_190518.jpg 20150901_190530.jpg
     
  2. wasilikoslow

    wasilikoslow New Member

    Trophy Points:
    3
    0kpGBY.jpg if you can add some black brush strokes its will be better I think :) But I liked it
     
  3. OBI WAN KEN0B1

    OBI WAN KEN0B1 Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    1,036
    THANKS it look a little shiny be cause of the flash.
     

Share This Page