Can someone with solidworks help me modify a .step file?

Anakin Starkiller

Master Member
RPF PREMIUM MEMBER
Hello everyone,

I'm in need of a little help. I have a part that I've designed in .step format. I'm looking to get this part machined. However, there is a section on this part that should have knurl added to it, and I am unable to model the knurl myself.

Is there anyone here who works with Solidworks (or an equivalent) that could help me out by adding the knurl to my part?

Thanks

Dan Stokes
danielstokesjr@gmail.com
 
I may be able to give you a hand with this. Send me an email with the part and some details about where the knurl needs to be, angle, depth and spacing of the knurl etc. I'll see what i can do with it!
mwiggins7024@gmail.com
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top