-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Done / Completed PRICEDROP just $11!C1 Personal Comlink / Hovimix 3D STL file (3 options for ANH, Scout & The Mandalorian) with Freebies
- Thread starter Jack2155
- Start date
Just so people can see what these look like printed on a Prusa Mini by someone who is absolutely not a printing guru, here's what I managed to accomplish. The tomtit cylinder was printed horizontally at 0.1mm layer height with a 0.4mm nozzle, the other parts were printed at 0.07mm layer height with a 0.25mm nozzle. No cleanup other than removing supports, the strings on the tomtit should be taken care of pretty easily.
And here are a couple of less successful attempts compared to the better ones. I tried the tomtit cylinder vertically, that didn't turn out nearly as well as printing it horizontally. The hovimix was printed with a 0.4mm nozzle and I think a 0.1mm layer height.
Thanks again Jack, these models look great, and they'll look much better printing on a resin printer.
And here are a couple of less successful attempts compared to the better ones. I tried the tomtit cylinder vertically, that didn't turn out nearly as well as printing it horizontally. The hovimix was printed with a 0.4mm nozzle and I think a 0.1mm layer height.
Thanks again Jack, these models look great, and they'll look much better printing on a resin printer.
Jack2155
Well-Known Member
Just so people can see what these look like printed on a Prusa Mini by someone who is absolutely not a printing guru, here's what I managed to accomplish. The tomtit cylinder was printed horizontally at 0.1mm layer height with a 0.4mm nozzle, the other parts were printed at 0.07mm layer height with a 0.25mm nozzle. No cleanup other than removing supports, the strings on the tomtit should be taken care of pretty easily.
Hey these look pretty good! The horizontal cylinder does indeed look better overall, the Hovi on the left looks sharp and even the lettering came out pretty nice! Thanks for the posting the prints on an FDM Mr.Max! I appreciate it!
Hey these look pretty good! The horizontal cylinder does indeed look better overall, the Hovi on the left looks sharp and even the lettering came out pretty nice! Thanks for the posting the prints on an FDM Mr.Max! I appreciate it!
