building a bio helmet

AnomiA

New Member
OK well i have already built a bio helmet outta card board hot glue paper mache and plaster of Paris as you can see in my picture.me and my dad are planning to make lots of predator gear and were gonna start by making a kick ass bio helmet. we don't wanna buy any so ya i need help.i was thing of buying a but-load of clay and sculpting what i want then putting plaster of Paris on but i figured i minus well ask my fellow hunters.

SUNP0002.JPG
 
You're already off to a wonderful start, all I could recommend is make sure to keep your mask proportional for your face unless you are planning to use a undermask, which can be a little harder to work cardboard around and still be visible. Their are lots of tips for paint jobs on this site to that might help give your mask the edge your looking for just keep looking. Your doing wonderfully.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top