Boba Fett build

STARL0RD

Well-Known Member
I recently started working on my Boba Fett armor and decided to do the whole thing. I have made my own templates for all but the dome which I got off of the Dented Helmet forums. I plan to cover the dome in wood filler and sand down to get rid of the seams and then I will permanently attach the faceplate to the helmet then attach the back.

Here are some progress pictures:
Photo on 8-18-15 at 2.31 PM.jpgPhoto on 8-18-15 at 2.32 PM.jpgPhoto on 8-18-15 at 2.32 PM #2.jpgPhoto on 8-18-15 at 2.32 PM #3.jpgPhoto on 8-18-15 at 2.32 PM #4.jpg
I apologize for the lighting
 
Nice symmetry with that visor section. I love Mandolorian helmets

If I may ask, why use wood filler over something like bondo?
well mainly because of cost. It works very well too so I figured, why not? I have actually started a new improved version ( just a bit more accurate) I will post pictures later
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top