Black Panther cowl

KJC

KJC

Active Member
I'm making a Black Panther cowl. This is the nearly done sculpt. I might make a junk mold and cast a resin master to save myself the hassle of smoothing the clay.
 
Last edited by a moderator:
Here is the final sculpt. I will be smoothing it out as best I can then priming and sealing for molding.
Black Panther final sculpt collage.jpg
 
looks great man, nice job. Although I do have one question - how do you breathe while wearing it? I don't seem to notice any holes
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top