Durasteel Corporation
Well-Known Member
Well to the extent that those seams COULD be vacuformed cuts is not out of the question in my mind to be sure.
The bulge on the back of the helmet would definately require some release.
I suspect the circular plate inside the helmet dome could have been a means to give it rigidity if it were thin plastic as most of these suits are.
The proof would be in examining the top of the helmet....if a seam exists, we can say its definately two halves. If not, and the seam only exists down the front and down the back, we can say it was vacformed as a solid piece but cut/split for releasing it.
The bulge on the back of the helmet would definately require some release.
I suspect the circular plate inside the helmet dome could have been a means to give it rigidity if it were thin plastic as most of these suits are.
The proof would be in examining the top of the helmet....if a seam exists, we can say its definately two halves. If not, and the seam only exists down the front and down the back, we can say it was vacformed as a solid piece but cut/split for releasing it.