Big Hero 6 - Megabot

Turbo Sausage

Active Member
Hi all,

Just wanted to share this little guy with you. There wasn't really any point taking progress pictures as he was basically just glued together and then painted. Modeled in 3DS MAX and 3D printed. He joins together with simple pegs into holes, I had thought about joining him together with magnets but I wanted it to be able to stand in this pose. Maybe I'll revisit it at some point and make a T-pose version with magnets. Hope you like it!



megabot001.jpgDSC_0012_5b.jpgDSC_0015_6.JPGFight_Bot.JPG
 
Last edited:
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top