Berserker Bio Helmet

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


rabbit

Well-Known Member
Hello just finished this bio helmet that I made! It was 3D printed in PLA filament and coated in XTC for extra strength. It was printed in 2 pieces, the mask itself and then the jaw bone.

Overall I had a blast printing and painting this pred, his armor has been one of my favorites for years.
 

Attachments

  • PSX_20200423_030730.jpg
    PSX_20200423_030730.jpg
    2.5 MB · Views: 129
  • PSX_20200423_030704.jpg
    PSX_20200423_030704.jpg
    2.6 MB · Views: 130
  • PSX_20200423_030643.jpg
    PSX_20200423_030643.jpg
    2.6 MB · Views: 122
  • 20200324_123827.jpg
    20200324_123827.jpg
    1.2 MB · Views: 123
  • 20200324_135840.jpg
    20200324_135840.jpg
    1.4 MB · Views: 123
  • 20200404_234907.jpg
    20200404_234907.jpg
    2.4 MB · Views: 118

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top