Batman's Grapple Gun Batman v Superman DOJ 3d print/model

astype

New Member
Never posted here before but have been here for a while. I also never 3d modeled before the beginning of this week. But I felt this was something worth posting. I haven't seen any else on the Grapple Gun from Dawn of Justice.

Here's my progress so far (my model is green if it isn't obvious):

http://imgur.com/G2g4ZCI
http://imgur.com/sZUzBfg

I started this two days ago and am still learning techniques to finish the gun. Mainly the handle/grip/stock not sure of the proper name. I am still off on some of the proportions. I gathered the base size from this still ( http://imgur.com/9YOdQY1 ) being roughly the same height as Ben I measured my hand and added an inch to compensate for the bat glove he is wearing.

I started 3d modeling the beginning of this week with the DOJ Bat-a-rang.
http://imgur.com/TWFpwtu
http://imgur.com/9FvsrsP
http://imgur.com/cYXZl8i

this is my 3rd model to date I did a Warhammer 4k pistol that I'll post after I paint it (modeled and printed already). Thoughts and advice welcome and appreciated.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top