Avp Pred Head Measurements

Thread starter Half Knife
Start date May 22, 2012

Half Knife

New Member

May 22, 2012

Is there a thread on here with this? I'm planning to start a 1/1 sculpt soon and I need the measurements of the full size head. Tip of the crown to the upper lip, width at the widest point, etc. Anything I can get. Thanks.

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.