Attaching a sling to the G&P Pulse Rifle

Knightjar

Sr Member
I've received my excellent sling from Noble (Thank you!). I'm now looking at ways to attach it. Movie-accuracy dictates attaching it to the stock and near the tip of the barrel but neither part looks strong enough on the G&P. I'm considering drilling and tapping a hole for a swivel stud in the rear of the Thompson, underneath the PR stock (not accurate but at least the right area) and maybe adding a reinforcing plate to the vent at the front. I'd love to know how others have done theirs.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top